[Domesteading 00177] Re: PLUMBING!!!!

[Robert Vance]

Ask the inspection agency what company has the ASTM approval and then go from there. either that or go for a small conventional one. I went for a conventional one and still am chagrined at the space it takes! 
BobV!
http://homepage.gallaudet.edu/janet.vance<http://homepage.gallaudet.edu/janet.vance> 
  ----- Original Message ----- 
  From: KyDomeLiving at aol.com<mailto:KyDomeLiving at aol.com> 
  To: domesteading at sculptors.com<mailto:domesteading at sculptors.com> 
  Sent: Saturday, April 21, 2007 2:06 PM
  Subject: [Domesteading 00176] Re: PLUMBING!!!!



  In a message dated 4/20/2007 12:34:26 PM Eastern Daylight Time,  sa
  l.cerda at rocketmail.com<mailto:l.cerda at rocketmail.com> writes:

  Congratulation on the plumbing.
  Too bad on the water heater.   Perhaps that same heater is sold by someone 
  else who HAS received the ASTM  approval.  Where did you buy it?
  Bosch Aquastar is an alternative, but  likely higher priced.


  Sal,
      Yes. I looked into the Bosch - ouch $900 was my  quote.....so it looks 
  like unless I can find a reference for the ASTM rating for  the one I now have 
  from someone, I will most likely be going down the road of a  conventional 
  electric hot water tank.
      Even then I am going to have to buy a narrow (18"  diameter) hot water 
  heater because that opening (door) is only 20" wide (rough  framed) - UGH! Thats 
  Life!! LOL
      
  Charlie in KY



  ************************************** See what's free at http://www.aol.com<http://www.aol.com/>.